|
32T C61160-180-200-220-235 |
 |
 |
 |
 HEAVY DUTY HORIZONTAL LATHE
| Models | C61160 | C61180 | C61200 | C61220 | C61235 | | Max.swing over bad | mm | 1600 | 1800 | 2000 | 2200 | 2350 | | MAX.swing over carriage | mm | 1250 | 1450 | 1650 | 1850 | 1950 | | Center height | mm | 830 | 930 | 1030 | 1130 | 1205 | | Width of bed | mm | 1615 | | Max.length of workpiece | mm | 3000-16000 | | Max.weight of workpiece between centers | kg | 32000 | | Max.torque of face plate | kg.m | 8000 | | Max.cutting capacity of independent tool post | kg | 9000 | | General cutting capacity | kg | 16000 | | Cone point angle of center and specification | | 75°;￠120 taper(1:7) | | Section dimension of tool shank | mm×mm | 70×70 | | Steps of spindle speed | | variable | | Range of spindle speed | r/min | 0.8-160 | | Taper bore in spindle | mm | ￠120;1:7 | | Diameter of face plate | mm | 1600 | 2000 | | Steps of feed | | 18 steps | | Range of longitudinal feed | mm/r | 0.125-48 | | Range of cross feed | mm/r | 0.063-24 | | Feed range of tool slide | mm/r | 0.063-24 | | Longitudinal rapid traverse speed | mm/min | 3000 | | Cross rapid traverse speed | mm/min | 1500 | | Max.travel of cross slide | mm | 725 | 800 | | Max.travel of tool slide compound | mm | 600 | | Pitch of metric thread | mm | 2-40 | | Inch thread | pitch/inch | 1-14 | | Module thread | mm | 1.5-20 | | Diameter of tailstock sleeve | mm | 300 | | Traversing capacity of sleeve | mm | 300 | | Spindle taper bore of tailstock | mm | ￠100 taper(1:7) | | Rapid traverse of tailstock | mm/min | 3000 | | Rapid traverse of sleeve | mm/min | 664 | | main motor | | 75KW 400-1200r/min | | Rapid traverse motor of tool post | 1.5KW 1500r/min | | Rapid traverse motor of tailstock | | Rapid traverse motor of tailstock sleeve | 1.1KW 1500r/min | | Power of lubricating pump of headstock | 1、4-jaw chuck (face plate)
2、close steady rest | 3、open steady rest
4、milling device | 5、grinding device
6、locking device of chuck |
 |
HEAVY-DUTY ENGINE LATHE